Enclosure

The primary activity today was getting the second piece of interior ceiling plywood (1/8" Baltic Birch) installed.  While the first piece only had to be fit from side to side, this one added the complexities of length and the vent fan cutout.

We trimmed the piece to width, fit it into the cabin, marked the length, cut to length, fit it again, marked the fan opening, cut the fan opening, fit it again, removed it, applied glue to the ribs and cross-members, then permanently installed the piece.

The above view is inside looking toward the rear.
 

The above view is from the front outside looking toward the rear.
 

This view is from the rear outside looking forward.

A section of the ceiling remains to be installed between the main yoke and the galley partition,  As we currently have no plywood left-overs that size, and that it does not factor into the electrical wiring, it is not a priority.

The electrical cavity face frame has been sanded and will be fit tomorrow, along with the shelf on which the Xantrex will mount.